6 Ft. Yellow and Black Striped Rubber Speed Bumps

Keep Drivers' Speed Down in Your Roadways, Lanes and Parking Areas!

Each speed bump is 72" long x 12" wide x 2-5/8" high with 3 contrasting stripes.

Ideal for high-volume traffic areas in your strata lot, business lot or other roadway, lane or parking area where a reduction of vehicle speed is desirable. Bonded reflective stripes don’t need painting. Made of tough, recycled tire rubber with UV stabilized, virgin rubber overlay.

Conforms to pavement surface. Two 1-1/4" channels on the bottom for drainage or for pipe, wire or cable routing. Speed bumps are removable for surface maintenance or snow plowing.

Easy, one-person installation. Includes 4 - 15" long rebar rods and washers for insertion through the moulded holes in the top of the speed bump and driving into an asphalt surface by use of a sledge hammer.

Installation of speed bumps onto a concrete surface requires special mounting bolts specific to the application. Caution must be taken in underground parking garages not to damage the rubber membrane below the surface of the concrete.

Please ensure that you have examined any applicable legislation for your specific application prior to installing any speed bumps.

Nameplate Detail Press

Even if you only produce a few nameplates a day, these machines can help by reducing the inventory of marked nameplates or ID tags. You will appreciate the legibility and uniformity of the plates or tags marked on these machines. Plates and tags are easy to read, with lettering evenly spaced, accurately aligned and uniformly deep.  The press is comfortable to operate, almost effortless, and may be operated from either a standing or sitting position. No special skills are required to turn out great looking, legible valve tags, dog tags or nameplates after only a few minutes of instruction and a couple of sample tags.

Model 4 or Model 6 Available.